Skip to content

437 hits on ””

Meet the safety requirements: Warm and hot water

At temperatures below 110 °C, good engineering practice is required. Above 110 °C it is about regulatory standards. We provide you with the right combination of level, pressure, flow switches and

Quick start your pressure maintenance

Imagine a unit for pressure maintenance that you can easily connect and get started. Sounds too good to be true? The lack of questions from our costumers concerning starting up is evidence of its

Reinforce the operational safety

Do you want to secure that your remote- or central heating unit always obtains heat? Opt for a double pump from us. We customize it to your needs and can educate you in the correct handling. 503

Extend the lifetime

Pre-pressured expansion vessels with bellows instead of membrane tend to rust less. This is because the fluid is not in contact with the vessel’s steel casing. We will provide you with a vessel that

De-gas your heating system

Air in the system is often the culprit behind reduced heat transfer, noise and corrosion. We know how to overcome the problems with the right products all the way from the district heating unit to

Minimize the risk of rust

We are happy to take the fight against rust with you. A system that is free from gas equals no potential for corrosion. The right knowledge and the right products give you the vacuum de-gassing you

Ensure water to the consumer

Sometimes there has to be water at a specific access point. A pump, for example, needs to be filled with water in order to pump water from a well. The solution is spelled check valves. 502

Minimize the noise

Pumps and pipe systems tend to make a bit too much noise sometimes. The cause is often air and gas. We make sure to remove the air and the gas from your system. 507

Armatec participates in the technology race within wind power

Armatec participates in the technology race within wind power Armatec participates in the technology race within wind power Wind power accounts for just over five percent of all electricity

Prefab technical rooms reduce material waste

Less building material waste means less environmental impact. With prefabricated units such as the Armatec Iziflex, we can reduce material waste. Since we assemble everything indoors – well protected

Showing 1-100 of 437 hits

Show 10 hits to